Lumasense-technologies LumaSoft Gas Multi Point 7860 Manual de usuario descargar pdf (Pagina 37)

Chapter 3

_________________________________________________________________________

________________________________________________________________________

BE6027-12 LumaSoft Gas Software LumaSense Technologies A/S

7810 and 7860 Page 37 of 194

3.2 Measurement set-up

The set up of a new measurement task is carried out in five steps.

3.2.1 Configuration

First step is System Configuration Setup, select Configuration in the

Set Up pull down menu (Figure 3.15) or select the icon from the task

bar.

Figure 3.15 Set-up pull-down: Configuration

The following System Configuration Set Up window will appear.

Figure 3.16 System Configuration SetUp

Then make check marks if any multiplexers (1303, 1309) are connected

to the Monitor. A maximum of four 1303 or two 1309 can be connected.

After finishing the set up, press OK.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 193 194

Sin comentarios

Lumasense-technologies LumaSoft Gas Multi Point 7860 Manual de usuario Pagina 37